C 3500 HD Truck 2WD V8-8.1L VIN G (2002)
4. Install the ignition coil wiring harness bolts. (Left side shown, right side similar).
Tighten the ignition coil wiring harness bolts to 12 Nm (106 inch lbs.).
5. Connect the ignition coil electrical connectors.
6. Install the ignition coil wiring harness.
7. Install a NEW valve rocker arm cover gasket if the gasket was removed from the rocker arm cover.
8. Install the valve rocker arm cover.
9. Install the valve rocker arm cover bolts.
10. Tighten the valve rocker arm cover bolts in sequence using two passes.
10.1.
Tighten the valve rocker arm cover bolts to 6 Nm (53 inch lbs.) on the first pass.
10.2.
Tighten the valve rocker arm cover bolts to 12 Nm (106 inch lbs.) on the final pass.
Important: Fully install the spark plug wires by pushing on the exposed end of the spark plug boot. Do not push the spark plug wire on the spark plug
by using the metal heat shield.