C 3500 HD Truck 2WD V8-8.1L VIN G (2002)
Shifter M/T: Service and Repair
Shift Lever Assembly Replacement
Shift Lever Assembly Replacement
Removal Procedure
Important:
-
Ensure that the control lever is positioned into the mechanical third or fourth gear prior to removal of the shift lever from the transmission. The
transmission must remain in this state when the shift lever is removed.
-
Do not disassemble the transmission shift lever. Internal parts for this shift lever are not available. Opening the shift housing lever voids the
warranty.
-
When removing the shift lever from the transmission, use the exposed bolts on the base of the lever.
1. Remove the control lever and boot.
2. Remove the boot.
3. Remove the shift lever bolts.
4. Remove the shift lever and seal.
5. Remove the shift lever insulator.
Installation Procedure
1. Install the insulator to the transmission case.
2. Install a NEW shift lever insulator.
3. Install the shift lever seat and lever.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the shift lever bolts.
-
Tighten the shift lever bolts to 20 Nm (15 ft. lbs.).
5. Install the boots.
6. Install the control lever and boot.
