Camaro V8-5.7L VIN G (1998)
7. Remove the brake caliper guide pin bolts.
8. Remove the caliper housing from the rotor and the knuckle. If the caliper is not being removed the vehicle, suspend the caliper from the front
suspension using a fabricated wire hook.
9. Inspect the following parts for corrosion, cuts, nicks or blockage. Replace any damaged parts. The caliper guide pin bolts The caliper guide pin
bushings . The brake hose fitting If corrosion and/or excessive wear is found, use new parts, including bushings, when installing the caliper. Do not
attempt to polish away corrosion.
INSTALLATION PROCEDURE
1. Lubricate the inner diameters of the caliper bolt bushings (2) with silicone grease.
2. Lubricate the caliper bolts (1). Use silicone grease. Do not lubricate the threads.
3. Inspect the caliper guide pins.
^
The caliper pin should slide through the pin bushings and caliper pin bores using only hand pressure.
^
If greater force is required, remove the caliper pin and the bushings.
4. Inspect the mounting bores for corrosion.
^
If corrosion exists, remove the corrosion using a 1-inch wheel cylinder brush.
^
Clean the mounting bores using clean denatured alcohol.
5. Replace the caliper pin and bushings. Refer to Brake Caliper Overhaul (Front).
6. Install the caliper onto the mounting plate and pads.
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
