Camaro V8-5.7L VIN G (1998)
7. Install the front brake caliper guide pins.
Tighten the front brake caliper guide pins to 31 Nm (23 ft. lbs.).
8. If the following components were removed, install them onto the caliper housing using new copper gaskets:
^
The brake hose fitting
^
The brake hose
Tighten the front brake hose fitting to 40 Nm (30 ft. lbs.).
9. Install the tire and the wheel.
10. Lower the vehicle.
Important: If the brake hose was removed, bleed the caliper. Refer to Hydraulic Brake System Bleeding.
11. Fill the master cylinder reservoir to the proper level with clean brake fluid.
12. With engine running, pump brake pedal until firm brake pedal is attained.
13. Check for leaks.
Brake Caliper Overhaul (Front)
