Camaro V8-5.7L VIN G (1998)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
REMOVAL PROCEDURE
Caution: For safety reasons, the Brake Pressure Modulator Valve (BPMV) must not be repaired, the complete unit must be replaced.
With the exception of the EBCM/EBTCM, no screws may be loosened If screws are loosened, it will not be possible to get the brake
circuits leak-tight and personal injury may result.
1. Turn the ignition switch to the OFF position.
2. Disconnect the EBCM/EBTCM harness connector (6)
Important: Note the locations of the brake pipes in order to aid in installation.
3. Disconnect the brake pipes from the Brake Pressure Modulator Valve (BPMV).
4. Remove the two nuts that connect the BPMV to the BPMV bracket (3).
Notice: When removing the brake pressure modulator valve, protect vehicle exterior from possible brake fluid spillage.
