Camaro V8-5.7L VIN G (1998)
Wiper Arm: Service and Repair
REMOVAL PROCEDURE
TOOLS REQUIRED:
J 39637 Wiper Arm Puller
1. Turn the ignition switch to RUN.
2. Set the wipers to the lowest DELAY setting.
3. Turn the ignition to OFF when the wipers are at the innerwipe (end of sweep) position.
4. Mark the position of the wiper blade on the windshield with a suitable marker or masking tape.
5. Raise the hood.
6. Lift the wiper arm nut cover.
7. Remove the nut.
8. Remove the wiper arm from the transmission drive shaft with the J 39637
9. Remove the wiper blade, if required.
INSTALLATION PROCEDURE
