Caprice Wagon V8-350 5.7L (1994)
7.
Locate the new jumper harness from the kit. Insert the red wire and terminal into cavity K2 of the electrical center (Figure 5). Cut the old terminals
from the brown and green wires removed from the electrical center in Step 5, and discard. Strip the ends of the wires. Crimp the ends of the wires
into the connectors on the brown and green wires in the new jumper harness. Heat shrink the connections to insure a water tight seal. Reinstall the
electrical center into the case.
8.
Reinstall the 40 amp Maxi-fuse.
9.
At connector C103, install the blue wire and terminal from the new jumper harness into cavity A (Figure 6). Plug the connector together.
