Cavalier L4-2.2L VIN 4 (1998)
12. Remove the case cover bolts.
13. Remove the case cover.
14. Install two 12 x 1.95 x 14 bolts in the dowel pin holes and tighten equally in order to pull the case cover loose
15. Inspect the drive link assembly. Refer to Drive Link Assembly Replacement.
INSTALLATION PROCEDURE
1. Install the case cover.
2. Install the case cover bolts.
^
Tighten the bolts to 24 Nm (18 ft. lbs.).
Install the check balls into the case cover.
NOTICE: Refer to Fastener Notice in Service Precautions.
3. Install the spacer plate gaskets.
4. Install the control valve body spacer plate.
5. Install the oil pump drive shaft.
6. Install the check ball into the control valve assembly.
