Cobalt L4-2.0L SC VIN P (2005)
1. Install the fuel feed pipe to the fuel rail.
NOTE: Refer to Fastener Notice in Service Precautions.
Using a backup wrench on the fuel rail tighten the fuel feed pipe to 14 N.m (10 lb ft).
2. Install the engine fuel feed pipe fastener located on the engine.
Tighten the fuel feed pipe fastener to 10 N.m (89 lb in).
3. Connect the engine fuel feed pipe to the chassis fuel flex hose.
4. Connect the negative battery cable.
5. Inspect for leaks using the following procedure:
1. With the engine OFF, turn ON the ignition for 2 seconds.
2. Inspect for fuel leaks.
3. Turn the ignition OFF.
4. With the engine OFF, turn ON the ignition for 2 seconds.
5. Inspect for fuel leaks.
6. Turn the ignition OFF.
6. Install the engine cover and nuts.
Tighten the nuts to 10 N.m (89 lb in).
