Cobalt L4-2.4L (2007)
Constant Velocity Joint Boot: Service and Repair
Wheel Drive Shaft Outer Joint and Seal Replacement (GKN)
Wheel Drive Shaft Outer Joint and Seal Replacement (GKN)
Tools Required
J35910 Drive Axle Seal Clamp Pliers
Disassembly Procedure
1. Clamp the drive axle shaft in a soft jawed vice.
2. Use a flat-bladed tool and disengage the retaining tabs of the large seal clamp.
3. Discard the clamp.
4. Remove the small seal clamp using side cutters and discard the clamp.
5. Separate the constant velocity (CV) joint boot from the CV joint race at the large diameter.
6. Slide the boot away from the joint along the wheel drive shaft bar.