Cobalt L4-2.4L VIN B (2006)
10. Remove the J 21177-A from the brake drum and position it over the corresponding brake shoe assembly at its widest point.
11. While holding the J 21177-A in position, insert a 0.635 mm (0.025 inch) feeler gage between one side of the J 21177-A, and the corresponding
brake shoe lining.
12. Rotate the brake shoe adjuster screw until the brake shoe linings contact the J 21177-A, and the feeler gage.
Brake shoe lining-to-drum clearance: 0.635 mm (0.025 inch)
13. Repeat the above steps for the opposite brake drum and brake shoe assembly.
14. Install the brake drums.
15. Adjust the park brake.
16. Install the rear tire and wheel assemblies.
17. Lower the vehicle.
18. Position the park brake lever boot to the floor console and press the boot retainer into place to secure.
