Corvette V8-5.7L VIN G (1997)
Front Fascia Emblem: Removal Procedure
REMOVAL PROCEDURE
1. Preheat the emblem to between 32°-38° C (90°-100°F) to aid in the removal of the molding.
2. Peel the emblem from the fascia.
3. Clean any remaining adhesive from the fascia using either a stripe removal disc or suitable cleaner.
^
3M(R) Scotch Bright Molding Adhesive and Stripe Removal Disc, or equivalent.
^
3M(R) General Purpose Adhesive Cleaner 08984, or equivalent.
Front Fascia Emblem: Installation Procedure
INSTALLATION PROCEDURE
1. Clean the contact surface of the fascia with a suitable cleaner. Use 3M(R) General Purpose Adhesive Cleaner 08984, or equivalent.
2. Warm the emblem and the emblem contact area of the fascia to 32°-38° C (90°-100°F).
3. Remove protective liner from the adhesive on the emblem.
4. Install the emblem to the locator holes in the fascia.
5. Press firmly on the emblem to secure the adhesive. Use a hand roller to wet out the entire emblem surface,
Lower Close Out Panel
