Corvette V8-5.7L VIN G (1997)
9. Remove the bearing cap bolts and studs.
10. Use the crankshaft bearing cap remover and the slide hammer in order to remove the bearing cap.
11. Measure the gauging plastic at its widest area using the scale supplied with the plastic gauging kit.
12. Compare the measurements to engine mechanical specifications.
^
If the gauging plastic shows irregularity in the journal exceeding 0.025 mm (0.0010 inch), remove the crankshaft and measure the journal with
a micrometer.
^
If the clearance is greater than engine mechanical specifications, select and install an undersized bearing set. Measure the clearance with
gauging plastic.
^
If clearance cannot be brought to specifications, replace the crankshaft or grind the crankshaft for use with the next undersized bearing.
