Corvette V8-5.7L VIN G (1997)
Important: When installing bolts throughout this procedure, be sure to use the correct bolt in the correct location as specified.
3. Install the control valve body bolts. Each numbered bolt location corresponds to a specific bolt size, as indicated by the following:
1 - M6 X 1.0 X 65.0
2 - M6 X 1.0 X 54.4
3 - M6 X 1.0 X 47.5
4 - M6 X 1.0 X 35.0
5 - M6 X 1.25 X 20.0
6 - M6 X 1.0 X 12.0
7 - M6 X 1.0 X 18.0
4. Install the manual detent spring.
5. Install the manual spring detent bolt.
6. Install the pressure switch assembly.
7. Install the pressure switch assembly bolts.
8. Install the wiring harness, the TCC solenoid and the O-ring seal.
9. Install the wiring harness bolts.
10. Install the TCC solenoid bolts.
11. Connect the electrical connectors to the valve body components.
Important: Certain bolts MUST be tightened in a spiral pattern as indicated by the arrows. If these bolts are tightened at random, the valve bores
may become distorted. This will inhibit valve operation.
NOTICE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use
paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint
clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid
damage to parts and systems.
12. Tighten the control valve body bolts in a spiral pattern starting from the center, as indicated by the arrows.
-
Tighten the control valve body bolts (in sequence) to 11 Nm (97 inch lbs.).
