Corvette V8-5.7L VIN G (1997)
-
J 36850 Transmission Assembling Lubricant
1. Install the 3-4 accumulator pin into the transmission case.
2. Install the 3-4 accumulator piston onto the pin. Ensure that the piston legs face away from the transmission case.
3. Install the 3-4 accumulator piston spring.
4. Install the J 25025-B to the transmission case.
5. Install the case gasket and the valve body gasket to the spacer plate. Use the J 36850 in order to retain the gaskets to the spacer plate.
-
The case gasket is identified by a C. Be sure to place the case gasket on the transmission case side of the spacer plate.
-
The valve body gasket is identified by a V. Be sure to place the valve body gasket on the valve body side of the spacer plate.
6. Install the spacer plate and the gaskets to the transmission case.
7. Install the spacer plate support and the spacer plate support bolts.
-
Tighten the spacer plate support bolts to 11 Nm (97 inch lbs.).
NOTICE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use
paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint
clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid
damage to parts and systems.
8. Install the 1-2 accumulator inner and outer springs to the piston.
9. Install the 1-2 accumulator piston to the accumulator cover. Ensure that the piston legs face the accumulator cover.
10. Install the 1-2 accumulator cover and the cover bolts.
-
Tighten the 1-2 accumulator cover bolts to 11 Nm (97 inch lbs.).
11. Remove the J 25025-B from the transmission case.
12. Install the control valve body.
13. Install the transmission oil pan and filter.
14. Lower the vehicle.
