Corvette V8-5.7L VIN G (1997)
24. Crimp the small seal retaining clamp using the J 42572.
-
Tighten the small seal retaining clamp until the base of the omega shape has a gap width (1) between 2 and 3 mm (0.079 and 0.118 in), with a
difference in the gap width from side to side no greater than 0.4 mm (0.016 in). The clamping hold time must be no less than 2 seconds.
25. Measure the distance (1) between the end of the seal and the end of the joint outer race; adjust the plunging motion of the joint accordingly.
Specification
226 ±4 mm (8.90 ±0.16 in)
26. Position the large seal retaining clamp (2) onto the seal (3).
27. Position the seal and large retaining clamp to the joint outer race (4) as shown.
28. Measure the distance (1) between the edge of the seal and the edge of the joint outer race last groove closing edge; adjust fit accordingly.
Specification
0.8 mm (0.03 in)
Important: The seal must not be dimpled, stretched or out of shape in any way.
29. Inspect the seal for proper shape. If the seal is NOT shaped correctly, equalize the pressure in the seal and shape the seal properly by hand.
30. Inspect the seal for damage. If the seal has been cut or punctured during assembly, you must discard and replace the seal.
Important: The seal retaining clamp must not be over-tightened or under-tightened.
