Corvette V8-5.7L VIN G (1997)
9. Remove the flexplate to torque converter bolt.
10. Remove the J 39411.
11. Repeat steps 7 through 10 to remove the 2 remaining bolts.
INSTALLATION PROCEDURE
1. Using a flat bladed screwdriver, remove the transmission torque converter access plug.
2. Align the one of the torque converter bolt holes with the driveline support assembly access hole, if necessary. Carefully rotate the torque converter,
working through the access holes in the rear bell housing and the transmission housing.
3. Align the one of the flexplate bolt holes with the driveline support assembly access hole, if necessary.
-
Remove the J 39411 from the engine flywheel.
-
Slowly turn the engine flywheel through the starter motor opening until the desired flexplate bolt hole lines up with the torque converter bolt
hole.
-
Install the J 39411 to the engine flywheel, in order to keep the flywheel from turning.
