Corvette V8-5.7L VIN G (1997)
10. Install the EBTCM LH mounting bracket into position.
11. Align and install the insulators attached to the EBTCM LH mounting bracket to the EBTCM.
12. Install the EBTCM LH mounting bracket mounting bolts.
-
Tighten the EBTCM LH mounting bracket mounting bolts to 50 Nm (37 ft. lbs.).
13. Remove the tie-off retainers from the muffler assemblies.
14. Install the intermediate exhaust pipe to muffler bolts.
-
Tighten the intermediate exhaust pipe to muffler bolts to 50 Nm (37 ft. lbs.).
15. Install the rear tire and wheel assemblies.
16. Lower the vehicle.
17. Connect the negative battery cable.
