Corvette V8-5.7L VIN G (1997)
13. Remove the transmission shift rod clamp bolt.
14. Remove the shift control mounting bolts.
15. Raise the shift control to release the locator from the shifter bracket on the side of the driveline support assembly.
16. Release the shift control from the transmission shift rod clamp and remove the shift control assembly.
Installation Procedure
1. Install the shift control assembly to the transmission shift rod clamp.
2. Lower the shifter into position and insert the locator into the shifter bracket on the side of the driveline support assembly.
3. Install the shift control mounting bolts.
-
Tighten the shift control mounting bolts to 30 Nm (22 ft. lbs.).
NOTICE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use
paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint
clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid
damage to parts and systems.
4. Install the transmission shift rod clamp bolt.
-
Tighten the transmission shift rod clamp bolt to 30 Nm (22 ft. lbs.).
