Corvette V8-5.7L VIN G (1997)
7. Lift the boot away from the trim plate and remove the boot.
8. Remove the I/P accessory trim plate.
9. Remove the shift control closeout boot retaining nuts.
10. Remove the shift control closeout boot.
INSTALLATION PROCEDURE
1. Install the shift control closeout boot. Check that the closeout boot fully seats to the shift control lever seal and the base of the shift control
assembly (1).
2. Install the shift control closeout boot retaining nuts.
-
Tighten the shift control closeout boot retaining nuts to 12 Nm (106 inch lbs.).
