Corvette V8-5.7L VIN G (1997)
15. Disconnect the reverse lockout solenoid electrical connector.
16. Using the J 41099, remove the reverse lockout solenoid.
Installation Procedure
^
Tools Required:
-
J 41099 Gear Select/Reverse Lockout Solenoid Socket
1. Using the J 41099, install the reverse lockout solenoid.
-
Tighten the reverse lockout solenoid to 40 Nm (30 ft. lbs.).
NOTICE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use
paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint
clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid
