Corvette V8-6.2L (2008)
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
4. Tighten the knock sensor mounting bolt (1).
Tighten the knock sensor mounting bolt 1 to 20 N.m (15 lb ft).
5. Install the starter assembly (4), ONLY IF REMOVED. Refer to Starter Motor Replacement (See: Starting and Charging/Starting System/Starter
Motor/Service and Repair) .
6. Install the right catalytic convertor. Refer to Catalytic Converter Replacement - Right Side (6.0L) (See: Emission Control Systems/Catalytic
Converter/Service and Repair/Catalytic Converter Replacement - Right Side (6.2L))Catalytic Converter Replacement - Right Side (7.0L) () .
7. Install the right exhaust manifold. Refer to Exhaust Manifold Replacement - Right Side (6.0L) (See: Engine, Cooling and Exhaust/Exhaust
System/Exhaust Manifold/Service and Repair/Exhaust Manifold Replacement - Right Side (6.0L))Exhaust Manifold Replacement - Right Side
(7.0L) () .
Important: Perform the following procedure only if the battery has been disconnected.
8. Program the transmitters. Refer to Transmitter Programming (N. America and Japan, except Canada) (See: Testing and Inspection/Programming
and Relearning)Transmitter Programming (Canada and Europe) (See: Testing and Inspection/Programming and Relearning) .
