Corvette V8-7.0L (2007)
2. Install the recliner mechanism to the seat frame.
3. Install the seat adjuster to the seat cushion frame.
4. Loop and route the reclining mechanism cables under the seat cushion frame springs.
5. Position the actuators with the arrow on the hinge end of the actuator pointing forward and with the release cable clip opening pointed downward.
6. Insert the forward ends of the actuators into the actuator brackets.
7. Install the seat back and the actuator to the seat cushion frame with the hinge bolts.
8. Apply Loctite(TM) 271 to the hinge bolt threads.
Notice: Refer to Fastener Notice .
9. Install the hinge bolt nuts.
Tighten the hinge bolt nuts to 24 N.m (18 lb ft).
10. Install the pins to the forward ends of the actuators.
