Corvette V8-7.0L (2007)
8. Remove the master cylinder from the brake booster without disconnecting the brake pipes and position the master cylinder aside.
9. Disconnect the brake booster vacuum hose from the booster check valve.
10. Remove the instrument panel lower trim panel.
11. Remove the brake pedal position sensor.
12. Remove the retainer, washer, brake pedal pin, and brake booster pushrod from the brake pedal.
13. Remove the screw (3) from the telescoping column motor mounting bracket (5), if equipped.
14. Position the motor assembly to the right of the steering column.
15. Remove the brake booster mounting nuts and washers from the booster studs.
Important: The brake booster is retained to the cowl with push-on nuts.
16. In order to remove the booster from the cowl, perform the following steps:
