Corvette V8-7.0L (2007)
Rear Engine Plate: Service and Repair
Engine Rear Cover Replacement
Tools Required
*
J 41476 Front and Rear Cover Alignment (Crankshaft Oil Seal Area)
*
J 41479 Crankshaft Rear Oil Seal Installer
Removal Procedure
1. Remove the engine flywheel.
2. Remove the oil pan-to-rear cover bolts.
3. Remove the rear cover bolts.
4. Remove the rear cover and gasket.
5. Discard the rear cover gasket.
6. Clean and inspect the engine rear cover. Refer to Crankshaft Rear Oil Seal Housing Cleaning and Inspection.
Installation Procedure
Important:
