Corvette V8-7.0L (2007)
*
Do not reuse the crankshaft oil seal or rear cover gasket.
*
Do not apply any type of sealant to the rear cover gasket (unless specified).
*
The special tool in this procedure is used to center the crankshaft rear oil seal.
*
All gasket surfaces should be free of oil or other foreign material during assembly.
*
The crankshaft rear oil seal MUST be centered in relation to the crankshaft.
*
The crankshaft rear oil seal will be installed after the rear cover has been installed.
*
An improperly aligned rear cover may cause premature rear oil seal wear and/or engine assembly oil leaks.
1. Apply a 5 mm (0.2 in) bead of sealant 20 mm (0.8 in) in length, to the engine block. Refer to Sealers, Adhesives, and Lubricants for the correct
part number. Apply the sealant directly onto the tabs of the rear cover gasket that protrude onto the oil pan surface.
2. Install the rear cover gasket, rear cover, and bolts.
3. Install the rear cover bolts until snug. Do not overtighten.
