Corvette V8-7.0L (2007)
The opening in the dash-mat for the HVAC module drain should be aligned so that the drain opening in the cowl is approximately
centered in the dash-mat opening; allowing ample room for the module drain seal to fully seat against the cowl.
4. Inspect the dash-mat for proper alignment to the cowl. Align if necessary.
Notice: Do not force the HVAC module between upper I/P and lower I/P cross vehicle beams. Damage to the HVAC module can result.
Important: Spray a light coat of 3M(TM) P/N 08877 Silicone Lubricant Plus or equivalent onto the HVAC module heater cover to aid in
the installation process.
5. Install the HVAC module into the vehicle.
6. Reposition the center console wire harness and the corresponding electrical connectors rearward of the lower tie bar.
7. Install the recirculation housing to the HVAC module.
8. Install the recirculation housing retaining screws.
