Corvette V8-7.0L (2007)
Cross-Member: Service and Repair
Front Suspension Crossmember Replacement (Without ZO6)
Front Suspension Crossmember Replacement (Without ZO6)
Tools Required
*
J 28467-B Universal Engine Support Fixture
*
J 33432-A Transverse Spring Compressor
*
J 41803 Engine Support Fixture
Removal Procedure
1. Remove the generator from the accessory mounting bracket. Refer to Generator Replacement (6.0L) Generator Replacement (7.0L) .
2. Install J 41803 and J 28467-B and support the engine.
3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
4. Remove the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .
5. Remove the steering linkage outer tie rod end stud nuts (3). Refer to Rack and Pinion Outer Tie Rod End Replacement .
6. Disconnect the shock absorber solenoid electrical connector, if equipped.
7. Disconnect the electronic suspension control (ESC) sensor links.
8. Remove the stabilizer shaft from the vehicle. Refer to Stabilizer Shaft Replacement .
9. Disconnect the intermediate shaft lower coupling from the steering gear. Refer to Intermediate Steering Shaft Replacement .
10. Remove the bolts from the electronic brake control module (EBCM)/brake pressure modulator valve (BPMV) bracket. Refer to Brake Pressure
Modulator Valve Bracket Replacement .
11. Support and reposition the EBCM/BPMV and bracket away from the crossmember.