Corvette V8-7.0L (2007)
Installation Procedure
1. Insert the forward edge of the applique into the side reveal molding.
2. Firmly press the applique and the reveal molding together.
3. Replace the foam sealing tape if reusing the reveal molding.
* Extend the tape 2.0 mm (0.08 in) beyond the reveal molding ends.
* Do not stretch the tape to fit. The tape may shrink back, or creep, after installation, resulting in a gap which may cause a leak.
4. Position the windshield side reveal molding on the windshield frame.
Notice: Refer to Fastener Notice.
5. Install the windshield side reveal molding screws.
Tighten the windshield side reveal molding screws to 1.8 N.m (16 lb in).
6. Install the windshield weatherstrip side retainer and the weatherstrip.
Windshield Side Reveal Molding Replacement (Hardtop)
Windshield Side Reveal Molding Replacement (Hardtop)
Removal Procedure
