Cruze L4-1.4L Turbo (2011)
Engine Block Heater: Technical Service Bulletins
Engine - Procedure To Install Engine Oil Heater
INFORMATION
Bulletin No.: 11-06-01-001A
Date: March 08, 2011
Subject: Procedure for Installation of an Engine Oil Heater
Models:
2011 Chevrolet Cruze
Supercede:
This bulletin is being revised to add information for the 1.8L (RPO LUW) Engine. Please discard Corporate Bulletin Number 11-06-01-001 (Section 06
- Engine/Propulsion System).
If a customer is in an area of extreme cold, where the temperature falls below -30°C (-22°F), it is recommended that they install an engine oil heater.
This will provide easier cold starting and better protection for the engine at extremely low temperatures.
Important
Please inform the customer that the engine oil heater should be plugged in a minimum of three hours prior to starting the vehicle.
Using the parts listed below, follow the applicable procedure to install the engine oil heater.
1.4L Engine (RPO LUJ)
1. Raise and support the vehicle.
2. Loosely install the heater bracket to the engine block using provided bolt.
3. Clean the oil pan surface and wipe dry with a clean lint-free towel prior to installing the heater.
4. Apply the paste to the back side of the heater. Evenly coat the entire surface.
5. Install the heater to the oil pan and retain using the bracket.
Tighten
Tighten the bolt to 40Nm (30 lb ft).
