Cruze L4-1.4L Turbo (2011)
1. Connect the actuator rod (3) to the detent lever assembly.
2. Install the manual shaft detent (with shift position switch) lever assembly (4).
3. Install the manual shaft (2).
4. Install the manual shaft detent lever hub pin (1) to height of 7.9 mm (0.38 in) (b).
Caution: Use J 41229 to install the manual shaft pin at the correct height in order to properly secure the manual shaft. If you install the pin too
deep, the case bore may crack.
5. Install the NEW manual shift shaft pin (5) using DT-41229 - pin installer. Use a NEW pin to ensure proper engagement with the case.
6. Inspect pin installed height is within 7.2-8.2 mm (0.28-0.32 in) (a).
7. Install the control valve body. Refer to Control Valve Body Replacement (See: Transmission and Drivetrain/Automatic
Transmission/Transaxle/Valve Body/Service and Repair/Control Valve Body Replacement).
8. Perform the transmission adaptive values learn procedure. Refer to Transmission Adaptive Values Learn (See: Transmission and
Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Programming and Relearning).
