Equinox AWD V6-3.4L (2008)
1. Install the cruise brake switch retainer into the upper hole of the brake pedal assembly with the retainer arrow pointing in the 3 o'clock position.
Important: Do not depress the brake pedal assembly during the cruise brake switch installation. Depressing the brake pedal during the
cruise brake switch installation will cause a brake drag condition.
2. Install the cruise brake switch.
*
Position the switch into the retainer with the electrical connector index notch pointing to the 1 o'clock position.
*
Slide the switch in the retainer until the plunger is fully depressed into the barrel.
*
Rotate the switch clockwise until the travel stop has been reached, approximately 60 degrees.
*
Inspect the cruise brake switch to ensure the switch is properly locked into the switch retainer with the cruise brake switch electrical connector
index notch pointing to the 3 o'clock position.