Equinox AWD V6-3.4L (2008)
Important: The holes in the control valve body cover wiring connector hole seal must face toward the control solenoid valve assembly. If
the holes face toward the valve body cover, there is a potential for a leak around the seal.
1. Install the control valve body cover wiring connector hole seal.
2. Install the control valve body cover gasket to the control valve body cover.
3. Install the control valve body cover.
4. Lower the transmission and remove the transmission jack.
Notice: Refer to Fastener Notice .
Important: Install all control valve body cover bolts and studs by hand then torque all bolts and studs in sequence.
5. Install the 12 control valve body cover bolts (1) M6 x 30.
Tighten the bolts in sequence to 12 N.m (106 lb in).
6. Install the 2 control valve body cover studs (2) M6 x 30.
Tighten the studs in sequence to 12 N.m (106 lb in).
