Express 2500 V8-6.6L DSL Turbo (2010)
4. Install the oil pump driven gear.
Caution: Do not use an impact driver to remove or install the oil pump driven gear nut. Use of an impact driver may shear the oil pump drive
gear pin in the crankshaft.
5. While holding the secondary oil pump shaft with a hex driver, install the oil pump driven gear nut and tighten to 100 Nm (74 lb ft).
6. Install the engine front cover. Refer to Engine Front Cover Replacement (See: Timing Components/Timing Cover/Service and Repair).
