Express 2500 V8-6.6L DSL Turbo (2010)
9. Connect the fuel injector electrical connectors (1).
10. Position the engine wiring harness, and install the engine wiring harness bracket fasteners (1) and tighten to 21 Nm (15 lb ft).
11. Install the glow plug module and bracket. Refer to Glow Plug Control Module Replacement (See: Glow Plug System/Glow Plug Control
Module/Service and Repair/Glow Plug Control Module Replacement).
12. If equipped, install the auxiliary generator. Refer to Auxiliary Generator Replacement (KD9) (See: Starting and Charging/Charging
System/Alternator/Service and Repair/Auxiliary Generator Replacement (KD9)).
13. Install the upper fan shroud. Refer to Engine Coolant Fan Upper Shroud Replacement (4.3L, 4.8L, 5.3L, 6.0L, 6.2L, 7.0L) (See: Engine, Cooling
and Exhaust/Cooling System/Fan Shroud/Service and Repair/Engine Coolant Fan Upper Shroud Replacement) Engine Coolant Fan Upper Shroud
Replacement (Diesel) (See: Engine, Cooling and Exhaust/Cooling System/Fan Shroud/Service and Repair/Engine Coolant Fan Upper Shroud
Replacement).
14. If the fuel injectors were replaced, refer to Fuel Injector Flow Rate Programming (See: Procedures).
15. Prime the fuel system. Refer to Fuel System Priming (See: Service and Repair/Fuel System Priming).
16. Start the engine. If the engine stalls, repeat the above step.
17. Once the engine starts, inspect for fuel leaks.
VIN 6
