Express 2500 V8-6.6L DSL Turbo (2010)
1. Install the left fuel feed pipe.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Connect the fuel feed pipe fitting to the left fuel rail and tighten to 41 Nm (30 lb ft).
3. Connect the fuel feed pipe fittings to the fuel injector pump and tighten to 41 Nm (30 lb ft).
4. If equipped, install the auxiliary generator. Refer to Auxiliary Generator Replacement (KD9) (See: Starting and Charging/Charging
System/Alternator/Service and Repair/Auxiliary Generator Replacement (KD9)).
5. Install the A/C compressor.
6. Prime the fuel system. Refer to Fuel System Priming (See: Service and Repair/Fuel System Priming).
7. Start the engine.
If the engine does not start, repeat the above step.
8. Inspect the fuel system for leaks.
