Express 3/4 Ton Van V8-4.8L VIN V (2003)
Electronic Brake Control Module: Service and Repair
Electronic Brake Control Module (EBCM) Replacement
Removal Procedure
Important: After installation, calibrate the new EBCM to the tire size that is appropriate to the vehicle.
1. Disconnect the negative battery cable.
2. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
Important: The area around the EHCU MUST be free from loose dirt to prevent contamination of disassembled ABS components.
3. Thoroughly wash all contaminants from around the EBCM.
4. For cutaway vehicles. remove the splash shield.
5. Disconnect the electrical connectors from the EBCM.
