Fuel Injector Testing and General Diagnostics
1. Install any components or connectors that have been removed or replaced during diagnosis.
2. Perform any adjustment, programming or setup procedures that are required when a component or module is removed or replaced.
3. Turn OFF the ignition for 60 seconds.
4. Turn ON the ignition, with the engine OFF.
5. Clear the DTCs.
6. If the repair was related to a DTC, duplicate the Conditions for Running the DTC and use the Freeze Frame/Failure Records, if applicable, in order
to verify the DTC does not reset. If the DTC resets or another DTC is present, refer to the Diagnostic Trouble Code (DTC) List - Vehicle and
perform the appropriate diagnostic procedure. See: Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code
Descriptions
OR
If the repair was symptom related, duplicate the conditions under which the customer concern occurred to verify the repair. If the customer
concern reoccurs, return to Symptoms - Vehicle and perform the appropriate symptom diagnostic. See: Testing and Inspection/Initial Inspection
and Diagnostic Overview
