Impala V6-3.8L SC VIN 1 (2005)
10. Twist together 1 end from each of the wires in order to short the wires. Deployment wires shall remain shorted, and not connected to a power
source until you are ready to deploy the inflator module.
11. Twist together 2 connector wire leads, the high circuits from both stages of the steering wheel module, to one of the deployment harness wires.
Refer to SIR Connector End Views in order to determine the correct circuits.
12. Inspect that the 3 wire connection is secure.
13. Bend flat the twisted connection.
14. Secure and insulate the 3 wire connection to the deployment harness using electrical tape.
15. Twist together 2 connector wire leads, the low circuits from both stages of the steering wheel module, to the deployment harness wire. Refer to
SIR Connector End Views in order to determine the correct circuits.
16. Inspect that the 3 wire connection is secure.
17. Bend flat the twisted connection.
