Impala V6-3.8L SC VIN 1 (2005)
7. Pull the module gently away from the steering wheel.
8. Remove the connector position assurance (CPA) for each module electrical connector.
9. Disconnect the yellow SIR coil lead wire connectors from the module.
10. Rotate the horn wire (4) counterclockwise until the wire unlocks from the cam tower post. Remove the horn wire from the steering wheel.
11. Remove the driver SIR module (5).
12. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required
retention period. Refer to Inflator Module Handling and Scrapping.
INSTALLATION PROCEDURE
1. Position the horn wire (4) into the cam tower post. Rotate the horn wire clockwise until locked. The horn wire must be below the top, left, module
mounting post.
2. Connect the yellow SIR coil lead wires to the module connectors. Connect pink to pink and gray to gray.
3. Install the CPA to each connector.