Impala V6-3.9L (2007)
1. Install the mounting bracket and the gasket on to the spotlamp outer tube shaft.
2. Apply a small amount of RTV sealer GM P/N 12345336 or Canadian P/N 12346286 or equivalent to the screw holes on the windshield pillar.
3. Install the mounting bracket, the gasket and the spotlamp outer tube shaft through the windshield pillar.
Notice: Refer to Fastener Notice in Cautions and Notices.
4. Install the spot lamp mounting bracket screws.
Tighten the spot lamp mounting bracket screws to 3.5 N.m (31 lb in).
5. Rotate the spot lamp to the upright position.
Point the spot lamp forward.
6. Tighten the spot lamp mounting bracket set screw just enough in order to firmly hold the spot lamp in the upright position.
7. Install the rubber grommet to the outer tube shaft.
8. Install the spot lamp handle onto the outer tube shaft in the vertical down position until the handle bottoms out, and the flat detent on the outer tube
shaft is exposed through the wedge key screw hole.
9. Install the spot lamp wedge key screw.
Tighten the spot lamp wedge key screw to 7.5 N.m (66 lb in).
10. Connect the electrical connector.
11. Install the spot lamp wiring harness push-in retainer to the windshield garnish molding, pressing in until fully seated.
12. Inspect the spot lamp for proper operation.
