Impala V8-5.3L (2008)
Wheel Bearing: Service and Repair
Rear Suspension
Rear Wheel Bearing and Hub Replacement
Removal Procedure
Important: The wheel bearing in the rear wheel hub is integrated into one unit. The hub is non-serviceable. If the hub and/or bearing is
damaged, replace the complete hub and bearing assembly.
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the tires and wheels. Refer to Tire and Wheel Removal and Installation (See: Service and Repair) .
3. Remove the brake rotor. Refer to Rear Brake Rotor Replacement .
Rear Wheel Speed Sensors
4. Remove the ABS electrical connector from the wheel speed sensor (1), if equipped.
5. Remove the park brake cable from the park brake actuator. Refer to Parking Brake Rear Cable Replacement (Z7U) .
6. Remove the mounting bolts from the rear bearing/hub.
7. Remove the wheel bearing/hub and park brake assembly from the knuckle.
8. Remove the park brake actuator from the rear wheel bearing/hub. Refer to Parking Brake Actuator Replacement .
Installation Procedure
1. Install the park brake actuator to the rear wheel bearing/hub. Refer to Parking Brake Actuator Replacement .
2. Install the wheel bearing/hub and park brake assembly to the knuckle.
