Impala V8-5.3L (2008)
4. Tighten the wheel nut (1) until the wheel stud is fully seated against the hub flange.
5. Back off the wheel nut (1) and remove the washers (3).
6. Install the support. Refer to Park Brake Support Replacement .
7. Install the rear wheel bearing/hub assembly. Refer to Rear Wheel Bearing and Hub Replacement (See: Wheel Bearing/Service and Repair/Rear
Suspension) .
8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Service and Repair) .
9. Lower the vehicle.