Impala V8-5.3L VIN C (2006)
13. Inspect the caliper bracket bolt boots on the caliper bracket for the following conditions:
^
Cuts
^
Tears
^
Deterioration Replace any damaged caliper bracket bolt boots.
14. Inspect the caliper bolts (2) for corrosion or damage. If corrosion is found, use new caliper bolts, including bushings, when installing caliper.
Installation Procedure
1. Install the caliper (3) over the rotor (4) and the caliper bracket (1). Ensure that the bushings are in place.
2. Lubricate the caliper bolts (1 and 3). Use silicone grease. Do not lubricate the threads.
3. Lubricate the 2 bolt boots (13 and 4) in the caliper bracket (12). Use silicone grease.
4. Notice: Refer to Fastener Notice in Service Precautions.
Install the caliper bolts (1 and 3). Ensure that the bolt boots fit securely in the groove of the caliper bolts. Be sure not to pinch or tear the boots. If
the boots are damaged, they must be replaced.
Tighten the bolts to 44 Nm (32 ft. lbs.).
