K 1500 Suburban 4WD V8-5.3L VIN T (2002)
3. Install the brake hose bracket bolt and the bracket to the steering knuckle.
Tighten the bolt to 9 Nm (80 inch lbs.).
4. Install the brake hose bracket bolt and the bracket to the upper control arm.
Tighten the bolt to 9 Nm (80 inch lbs.).
5. Install the brake hose into the brake hose bracket.
6. Install the brake hose retaining clip (3).
7. Remove the rubber cap or plug from the brake pipe fitting end.
8. Connect the brake pipe fitting end (1) to the brake hose (2):
^
Use a backup wrench on the brake hose fitting end (2).
^
Do not bend the mounting bracket or the brake pipe.
Tighten the brake pipe fitting end (1) to 25 Nm (18 ft. lbs.).
9. Bleed the hydraulic brake system.
10. Install the tire and wheel assembly.
Important: Ensure that the brake hose does not make contact with any part of the suspension or the tire/wheel assembly. Check the brake hose in
extreme right and left turn conditions. If the brake hose makes contact remove the brake hose and correct the condition.
11. Lower the vehicle.
Rear Caliper
Brake Hose Replacement - Rear (Caliper)
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly.
3. Clean all dirt and foreign material from the brake hose end and brake pipe fitting.
Important: Install a rubber cap or plug to the exposed brake pipe fitting end in order to prevent brake fluid loss and contamination.
