Malibu L4-2.4L (2010)
6. Remove the remaining oil pan bolts and the oil pan.
7. Remove the oil pan gasket.
8. Remove all traces of the old gasket material. Clean the transaxle case and oil pan gasket surfaces with solvent, and allow to air dry.
Installation Procedure
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
1. Install the oil pan gasket, the oil pan, and hand start the oil pan bolts.
Tighten the oil pan bolts to 12 Nm (9 lb ft).
2. Lower the vehicle.
3. Refill the transaxle using DEXRON(R) VI fluid to the specified refill capacity. Refer to Transmission Fluid Level and Condition Check (See:
Testing and Inspection/Symptom Related Diagnostic Procedures/4T45-E - Automatic Transmission/Transmission Fluid Level and Condition
Check).
*
The bottom pan removal capacity is approximately 6.5 L (6.9 qt).
*
The complete overhaul capacity is approximately 9 L (9.5 qt).
*
The dry capacity is approximately 12.2 L (12.9 qt).
