Malibu V6-3.1L VIN J (2002)
3. Install the fuel filler pipe attaching screws to the fuel filler pipe access panel.
Tighten
The fuel filler pipe attaching screws to 10 N.m (89 lb in).
4. Connect the vapor recirculation line at the fuel filler pipe.
5. Install the fuel filler hose to the fuel tank and filler tube.
6. Inspect and make sure filler hose is fully seated on fuel tank port, and fuel filler pipe.
7. Make sure clamp is properly located on tank port between the bead and tank.
Tighten
Tighten the fuel tank filler pipe hose clamps to 3 N.m (27 lb in)
8. Lower the vehicle
9. Refill the fuel tank
10. Tighten the fuel filler cap
11. Reconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Starting and Charging.
12. Inspect for fuel leaks using the following procedure:
12.1. Turn ON the ignition for 2 seconds.
12.2. Turn OFF the ignition for 10 seconds.
12.3. Turn ON the ignition.
12.4. Inspect for leaks.
