Malibu Classic L4-2.2L (2008)
10. Remove the support assembly to body bolts.
Important: Mark location of support assembly to body rails with a dab of paint.
11. With the aid of an assistant, remove the support assembly from the vehicle.
12. Remove the stabilizer shaft.
Installation Procedure
1. Install the stabilizer shaft.
2. With the aid of an assistant, position the support assembly to the vehicle.
3. Using a suitable jack stand, support the support assembly.
Notice: Refer to Fastener Notice.
Important: Install support assembly to body rails by location of paint.
4. Install the support assembly to body bolts.
Tighten the bolts to 100 N.m (74 lb ft) plus 30 degrees.
5. Remove the jack stand.
6. Install the muffler.
7. Connect the vehicle wiring harness to the clips on the support assembly.
