Metro L3-061 1.0L VIN 6 TBI (1998)
INSTALLATION PROCEDURE
1. Apply silicone grease to the master cylinder piston.
2. Install the booster assembly to the bulkhead. Do not tighten the mounting nuts.
3. Install the push rod clevis (5) to the brake pedal. Secure the push rod clevis with a clevis pin (6) and cotter pin (1).
4. Secure the booster assembly mounting nuts.
^
Tighten the booster assembly mounting nuts to 13 Nm (115 inch lbs.).
5. Install the hose to the booster assembly. Secure the hose with a hose clamp.
6. Install the master cylinder.
7. Install the hydraulic modulator/motor pack assembly (if equipped with ABS).
