Metro L3-061 1.0L VIN 6 TBI (1998)
4. Install the PCV hose to the cylinder head cover.
5. Install the following vacuum hoses:
^
The EVAP canister hose.
^
The manifold absolute pressure sensor hose to the intake manifold or to the TB.
^
The brake booster hose to the intake manifold.
6. Install the coolant hoses (2, 3, and 4) to the TBI unit (4) and the intake manifold.
7
Install the fuel return (2) and the fuel feed (3) hoses to the TBI unit (4).
8. Connect the following electrical connectors:
^
The ECT sensor electrical connector
^
The coolant temperature sending unit connector
^
The EFE heater electrical connector (if equipped)
^
The ECT switch electrical connector
^
The TP sensor electrical connector
^
The EGR solenoid vacuum valve electrical connector
^
The ISC motor electrical connector
^
The ground wires to the intake manifold
^
The TBI unit electrical connector
9. Secure the wiring harness to the retaining clamps.
10. Install the accelerator cable to the TBI unit.
11. Adjust the accelerator cable play to specifications.
12. Install the air cleaner assembly to the TBI unit.
13. Reconnect the negative battery cable.
14. Refill the engine coolant.
15. Upon completion of the installation, start the engine and check for fuel and engine coolant leaks.
